3D Printing a Fishing Lure: Part III
Matt and I are almost finished three lipless crankbait prototypes. A printing place in Toronto recommended we use ABS plastic, which will be strong, waterproof and will sink in water. These are all great qualities.
However, ABS's light weight will have to be considered, as this may negatively impact casting distance. Lipless crankbaits are usually in the 1/4 to 1/2 oz. range. We'll have to ask the printing place how much they think our prototypes will weigh.
Back to the designs:
For each design, I asked Matt to move the front ring a bit higher, as per my instructions in the images below, which is more in line with traditional lipless lures. I think this will make the lures run a little better in the water.
I'm really impressed with Matt's work and we're excited to almost be at the stage where we're ready to print these prototypes. They'll be finished in time for the bass opener. Stay tuned, and don't forget to check out Matt's website!
Greg Cholkan is a lawyer, fisherman and Hemingway impersonator. He works in Huntsville and Haliburton with Barriston LLP and his practice focuses on real estate, wills and estates, and corporate matters.
However, ABS's light weight will have to be considered, as this may negatively impact casting distance. Lipless crankbaits are usually in the 1/4 to 1/2 oz. range. We'll have to ask the printing place how much they think our prototypes will weigh.
Back to the designs:
I asked Matt to remove the bottom ring at the back end on this pink one: otherwise, two treble hooks might get tangled in each other. In any event, one should suffice for this design. And no, these aren't the final colours.
This yellow one may be my favourite: it's sleek and simple.
Greg Cholkan is a lawyer, fisherman and Hemingway impersonator. He works in Huntsville and Haliburton with Barriston LLP and his practice focuses on real estate, wills and estates, and corporate matters.
0 Response to "3D Printing a Fishing Lure: Part III"
Post a Comment